By A Mystery Man Writer
Threaded Backing Plates for replacing existing ø3-3/4 cup holders
Backing Plate for 70 Series Rod Holders Backing plates are very important to have under every rod holder used for heavy tackle fishing. When the rod holder is under extreme load, regular nuts and washers can concentrate stress and cause spider cracking around your rod holders, or perhaps even tear through, causing severe gunnel damage. Smith backing plates distribute mounting bolt pressure evenly over 30 times more surface area than with standard washers alone.
C E Smith Backing Plate F 70 Series Rod Holders
Stainless Steel Rod & Cup Holder Backing Plate for Round Rod/Cup Only for 3-3/4 HolesThreaded Backing Plates for replacing existing ø3-3/4 cup
Mate Series Stainless Steel Rod & Cup Holder Backing Plate f/Round Rod/Cup Only f/3-3/4 Holes - C1334314
MATE SERIES Cup Holder Conversion Kit Threaded backing plate for replacing existing 3-3/4 cup holders with round ABS plastic combination rod and cup holders. All hardware is included. Use with Round Top ABS Plastic Rod/Cup Holders only in an existing 3-3/4 hole. Access to the underside is not required.
Mate Series C1334314 Stainless Steel Rod & Cup Holder Backing Plate f/Round Rod/Cup Only f/3-3/4 Holes
Threaded Backing PlateC1334314 - Fishing Rod Holders, Boat Rod Holders
Backing Plate for 70 Series Rod Holders Backing plates are very important to have under every rod holder used for heavy tackle fishing. When the rod holder is under extreme load, regular nuts and washers can concentrate stress and cause spider cracking around your rod holders, or perhaps even tear through, causing severe gunnel damage. Smith backing plates distribute mounting bolt pressure evenly over 30 times more surface area than with standard washers alone.
C E Smith Backing Plate F 70 Series Rod Holders
Description, Combination Rod & Cup Holder, 316 Stainless with Round Top, 0º Rod Angle, Open at Bottom
Mate Series Rod & Cup Holder 0º Rod Angle Round Top Open at Bottom C1000ND
Mate Series Stainless Steel Rod Cup Holder Backing Plate f/Round
Threaded Backing Plates for replacing existing ø3-3/4 cup holders
Threaded Backing Plate, C1334314
Thick Made thicker for use with adjustable chucks, this extra thickness allows a large step to be machined on the front of the plate for use with the adjusting screws on the chuck. The remaining material safely supports and secures the chuck Supplied with studs as shown. All South Bend back plates are made of fine-grain cast-iron.
South Bend SB1394 - 6-1/4 D1-4 Back Plate - Thick
Mate Series Stainless Steel Rod Cup Holder Backing Plate f/Round
Mate Series Threaded Stainless Steel Backing Plate
Mate Series Threaded Stainless Steel Backing Plate
TMX Set Tru D1-4 Adapter Plate 3-875-054P for 5 Chucks
Rupp Large Stainless Steel Boltless Swivel Rod Holder 0 CA0127SS
THREADED M39 X 4 BACKPLATE / ADAPTER FOR 6 3 OR 4 JAW LATHE