Water House Connection Services in Anne Arundel County, MD

Most residential water service line replacements complete in one to two days depending on line size and site restoration. New construction jobs with both public and private side work can take longer if the County main is not yet in service at the property or if the Tap Connection Permit and pre construction conference are still being scheduled. Our team provides an estimate at consultation.

We install and replace water taps, meters, meter pits, curb stops, corporation stops, and full water service lines for residential and commercial properties.

A home connects to the municipal system through a water service line, typically Type K copper, running from a corporation stop at the main through a curb stop valve to the meter pit.

A licensed contractor taps the municipal water main via a corporation stop, runs a service line to the property, installs a curb stop valve, and connects to the meter and plumbing. In Anne Arundel County this requires a Tap Connection Permit for the public side, a cleared Miss Utility ticket, a Bureau of Utility Operations pre construction conference, and a separate Water/Sewer Connection Permit for the final tie in, plus MDE construction permit compliance.

Your water service line enters through the foundation wall nearest the street. The meter pit is typically at the property line; Anne Arundel County's Bureau of Utility Operations holds as built records for most county properties.

Type K copper is the preferred material for Maryland water service lines, offering corrosion resistance, long service life, and compliance with county installation standards.

Most residential connections are 3/4" or 1" in diameter. Higher demand homes and commercial properties typically require a 1 1/2" or 2" line, which we assess and install as part of a complete upgrade.

A corporation stop fitting is tapped directly into the pressurized municipal water main, allowing the new service line to branch off without interrupting supply. A curb stop ball valve is then installed for property level shutoff.

Maryland water service lines are buried at a minimum of 42 to 48 inches below grade per state and county frost depth requirements.

In Maryland, residential water service lines are generally installed between 42 and 48 inches deep, in line with frost depth standards and Anne Arundel County installation requirements.

The public side, from the main to the meter pit, runs under a Tap Connection Permit and may carry a user connection charge, a Front Foot Assessment Fee, and a quarterly use fee once metered. The private side, from the meter into the home, runs under a separate Water/Sewer Connection Permit and is billed as standard contractor labor and materials. We confirm which County charges apply to your address and quote both sides upfront so there is no surprise between them.

Cost depends on line size, distance from the main, and site conditions, rock and utility conflicts add time on some lots. The County's connection and permit charges are separate from our installation cost and are set by the Bureau of Utility Operations. We pull the current fees for your address and give you an itemized quote covering both charges before we start.

The Bureau of Utility Operations Construction Inspection Supervisor can be reached at 410-222-3274 for tap and inspection scheduling, and the Permit Center at 2664 Riva Road in Annapolis handles applications at 410-222-7700. We coordinate with both offices directly as part of our service, so you generally will not need to call them yourself once we are on the job.